SAMPLE PROJECT · Invented data, read-only · Back to xpcspine.com
XPC Spine PM3-REBUILDPaper Machine 3 Press and Dryer Section Rebuild
Help

Help ›

Live boards

What you save on a board shows on the PM and CM screens within seconds.

Master board CM roll-up PM board

How it works

  1. Every saved change is logged. Open screens ask for anything new every 8 seconds.
  2. The Live dot at the top shows the screen is following changes.
  3. The PM, CM and master pages show a 'Live from the boards' feed and refresh by themselves.
  4. If you are part-way through a form, a notice waits instead of reloading. Press Show it when you are ready.
  5. A foreman only hears about their own board.

Ask the guide

Shows the help topics that match your question.

Other topics

Getting started on a new project · Signing in, two-step and work accounts · Setting up a new project · Trade boards and trade leads · P6 schedule, Gantt and the scheduler · Working over each other · Safety control center · Safety training and OSHA cards · Rigging and lift plans · Meetings · Delay log · Client delay report · Change orders, back-charges and pay apps · Drawings, revisions and board photos · Procurement and document control · Client NDA · Client master board · Live connectors · Your scope page (contractors)